![]() ![]() The red wire of that 14-3 connects to the same side of the light socket as the red wire coming over from light #1.Īt the switch location if you are using a conventional simple toggle switch the black power wire of coming into the switch box will connect to the brass colored screw and the red wire will connect to the silver colored screw of the switch. In addition you have to run 14-3 from light #2 over to the switch location. The other two screws should connect to the center contact in the light socket and this is where you want to make sure to connect the red wires. Two of these should be connected to the threaded sleeve part of the light socket and this is where you want to make sure to connect your white wires. It appears from the pictures that the light sockets have have two screws for each side of the light. The white wires should connect to the same side of the light socket just as you did at light #1. You have connected the light #2 incorrectly. Mark both ends of the white wire with colored paint, tape or shrinkwrap.That is so the white wire will definitely test hot at all times, and it's not likely to be confused for a neutral. Use the white wire for always-hot, not switched-hot as you have.Use of a /2 switch loop is allowed if changing the cable is easy without tearing apart any part of the building, i.e. Your switch loop is wrongĬode requires a /3 cable for a switch loop so neutral is present for smart switches etc. That should solve it there's plenty of depth in a 1.5" octagon box to keep the grounds far away from the socket back face. Then finally the wires go in that actually attach to the lamp socket. those black bundles one of which will soon be a black-white-marked. The next layer above grounds is everything that doesn't tie to the lamp, i.e. ![]() ![]() This leads them on a snipe hunt looking for a ground problem, when it's something else. This will greatly aid troubleshooting often people wire grounds last after testing, and discover connecting grounds breaks the circuit. You should do this as the very first thing, and then never think about them again. The key here, however, is to push the grounds into the back of the box behind all other wires. Alternately you could use ground clips to attach to the sides of the box. They're biffing onto a neutral or hot terminal.Īlso, you need to use the #10-32 screw in the steel box and put a pigtail on that, and join that to the ground wires. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |